2016 November Cisco Official New Released 640-911 Dumps in Lead2pass.com!
100% Free Download! 100% Pass Guaranteed!
Lead2pass is now offering Lead2pass 640-911 dumps PDF and Test Engine with 100% passing guarantee. Buy Lead2pass 640-911 PDF and pass your exam easily. If you want real exam simulation then buy test engine and install on your pc for preparation.
Following questions and answers are all new published by Cisco Official Exam Center: http://www.lead2pass.com/640-911.html
An engineer has implemented EIGRP in the data center with a large OSPF routed environment. All EIGRP routes were functioning properly until enabling EIGRP route summarization. Legacy OSPF routes are now being used for route selection. Why have the routes changed?
A. EIGRP summary routes have a higher administrative distance than EIGRP specific routes
B. reduce the administrative distance for the EIGRP summarized routes
C. OSPF has a more specific route with EIGRP summarization enabled
D. increase the administrative distance for the OSPF route process
E. modify the bandwidth and delay metrics to be preferential over OSPF
What option tests hardware to verify that all components of the device are operational and present?
Where are start-up configurations saved on a Cisco router?
D. Boot Flash
A. MAC address of router interface Eth1
B. MAC address of router interface Eth2
C. MAC address of the NIC in the Server
D. MAC address of switch interface E1/9
A. IP address of the Server
B. MAC address of router interface eth1
C. IP address of router interface Eth1
D. MAC address of the Server
E. IP address of switch interface E1/9
F. MAC address of switch interface E1/9
A. The IP address and MAC of Server-1 will be associated with R1 interface Eth0.
B. The IP address and MAC of PC-A will be associated with R1 interface Eth1.
C. The IP address of Server-1 and MAC address of SW1 interface E1/1 will be associated with R1 interface Eth0.
D. The IP address of PC-A and MAC address of SW2 interface E1/48 will be associated with R1 interface Eth1.
E. The IP address of Server-1 and MAC address of SW1 interface E1/13 will be associated with R1 interface Eth0.
F. The IP address of PC-A and MAC address of SW2 interface E1/9 will be associated with R1 interface Eth1.
For a router to do an IP routing process, which part of a packet must be checked before consulting the routing table?
A. destination IP address
B. source IP address
C. destination MAC address
D. source MAC address
A design team is upgrading hubs to Layer 2 switches to decrease the number of collisions caused by media access control method. Which media access control protocol is affected by this change?
In which Cisco IOS mode of a Cisco router could an engineer issue show commands for verification purposes?
A. enable EXEC mode
B. user EXEC mode
C. global configuration mode
D. interface level mode
A. Eight additional Cisco Nexus 2000 switches can be connected in the same manner.
B. Sixteen additional Cisco Nexus 2000 switches can be connected eight individually to each 5596.
C. One additional Layer 3 expansion module can be installed in each 5596 to increase the Layer 3 forwarding capability.
D. FEX ports can be configured as router ports, extending Layer 3 redundancy to top of rack.
E. FEX ports can be configured for FCoE, reducing cabling footprint.
F. Sixteen additional Cisco Nexus 2000 switches can be connected in the same manner.
Which three attributes can be configured when creating a new user account on a Cisco Nexus 5000 Series Switch? (Choose three.)
C. expiry date
D. access list
E. role feature
F. authentication server
A network administrator is tasked with creating a switched virtual interface for VLAN 100 on a new Cisco Nexus switch. Which two commands does the network administrator need? (Choose two.)
A. feature interface-vlan
B. interface vlan 100
C. feature private-vlan
D. interface 100
E. interface mgmt 100
A network engineer is changing the boot process of a router from its original state to one that boots from ROMMON. Which option in Cisco IOS should be changed?
A. config register number
C. bootflash settings
D. terminal history
A. switch(boot)# load n5000-uk184.108.40.206.N1.4.bin
B. switch(boot)# configure terminal
switch(boot-config)# admin-password Cisco123
C. switch(boot)# load n5000-uk9-kickstart.5.2.1.N1.4.bin
D. switch(boot)# load system-latest
A. boot n5000-uk9-kickstart.5.2.1.N1.4.bin
B. load n5000-uk220.127.116.11.N1.4.bin
C. copy kickstart-latest n5000-uk9-kickstart.5.2.1.N1.4.bin startup
D. copy system-latest n5000-uk18.104.22.168.N1.4.bin
E. boot n5000-uk22.214.171.124.N1.4.bin admin-password Cisco123
F. load n5000-uk9-kickstart.5.2.1.N1.4.bin
Which three options describe routers compared to switches? (Choose three.)
A. use IP address tables for information lookup
B. concerned with packet forwarding
C. operate at Layer 3 of the OSI model
D. operate at Layer 2 of the OSI model
E. use MAC address tables for information lookup
F. concerned with the local delivery of frames
Which command can change the sequence of a router boot process?
Which two VTP modes allow the creation of local VLANs? (Choose two.)
A switch is configured to be part of a VTP domain so that its VLAN database is not affected by any changes in the domain. Which mode should be configured on this switch?
Which process does a Cisco router perform immediately upon powering up?
C. booting from NVRAM
D. booting from ROM
Now we are one step ahead in providing updated real exam dumps for 640-911. We provide 100% 640-911 exam passing guarantee as we will provide you same questions of 640-911 exam with their answers. Our Cisco 640-911 new questions are verified by experts.
640-911 new questions on Google Drive: https://drive.google.com/open?id=0B3Syig5i8gpDQVhxZ2ZFWXF4b2s
2016 Cisco 640-911 exam dumps (All 220 Q&As) from Lead2pass:
http://www.lead2pass.com/640-911.html [100% Exam Pass Guaranteed]